Bbpr Models - Valpes ER PLUS-Serie Installations- Und Bedienungsanleitung

EN
BBPR model
Following a power failure, the BBPR unit will reset after 5 minutes.
Actuators with security battery unit (on-off wiring mandatory)
BBPR model integrate a battery pack monitored by an electronic board inside the actuator. Its function is to relay
in case of power supply failure on terminal PIN 1,2 and 3 of the actuator. The BBPR system can be set on differ-
ent position like normally open (NO) or normally closed (NC). It depends on the application.
The electronic board monitors the battery pack and check the status of battery (cycle load and failure)
If a battery failure is detected , a contact on PIN 65 and 66 switch off. It's possible to use this contact to be
aware that there is a failure on battery in the actuator without remove cover and plan the replacement.
Fail safe option required ON/OFF mode.
Loading electronic board
Voltage
Battery capacity
Nominal current
Charging current
initial battery charge duration
Charging status feedback relay (65/66)
Failure feedback relay (D3/D4)
Temperature
C1
C2
REP TERMINALS DESIGNATION
17 (-)
C1 power supply connector
18 (+)
F (+)
C2 F (-) Battery unit connector
T (+)
A
C3 B Motor connector
C
D3
C4 1) Failure feedback connector
D4
65
C5 1) Charging feedback connector
66
A
C6 0 RS485 connector
B
J1 Bluetooth ® activation jumper
1) The auxiliary cables must be connected to inside installation only
DSBA3200 • Rév. 30/09/2020
14.4 V DC
600 mAh
600 mA
180 mA
3,5 h
24 V DC - 1 A max
24 V DC - 3 A max
-10 °C to +40 °C
L1
L2
C3
REP
L1
L2
L3
L4
L5
L6
L7
J1
COLOR DESIGNATION
Green Actuator operating into opening
Red Actuator operating into closing
Orange Wired functioning mode
Orange manual / Bluetooth
Orange Weekly scheduler functioning mode
Red Error detected
Slow blinking (1s) : battery charged.
Green
Rapid blinking (0.5s) : battery charging
L6 L4
L7 L5 L3
C6
C5
C4
® functioning mode
23