Problem Solving - Teka DBB Bedienungsanleitung

Cleaning and maintenance
During cleaning and maintenance work, make
sure the safety instructions are complied with.
Cleaning the hood body
• If your kitchen hood is made of stainless steel,
use proprietary cleaners mentioned in the
product instructions.
• If your kitchen hood is painted, use lukewarm
water and a neutral soap.
• Never use metallic scourers, nor abrasive or
corrosive products.
• Dry the kitchen hood using a cloth that does not
produce fibres.
• Do not use vapour cleaners.
Cleaning the metal filters
• To remove the filters from their fittings, press
lightly on the locks and then pull them off.
• The metal filters can be cleaned by soaking
them in hot water with neutral detergent until the
fat dissolves and then rinsing them under the tap
or using special anti-grease products. They can
Proceed with the following checks before calling the Technical Service:
Problem
The kitchen hood does not
work.
The kitchen hood does
not extract sufficiently or
vibrates.
The lamps do not light up.
When exterior gas extraction is not possible, then the kitchen hood may be set to purify the air by recycling
it through active charcoal filters.
The active charcoal filters have an active life of between three to six months, depending on the individual
conditions of use. These filters cannot be washed nor regenerated. They must be replaced once their useful
life comes to an end.
The manufacturer reserves the right to make changes and corrections to its products as it deems
necessary, without altering their basic characteristics.
• Cleaning in a dishwasher may damage the
• Once clean, leave them to dry off and then fit
• Lamps included in this product are designed
• These lamps are not apt for lighting domestic

Problem solving

Possible cause
The mains cable is not
connected to the network.
There is no current in the
network.
Filters are saturated with fat.
Obstruction in the air outlet.
The lamps are blown
The lamps are slack.
Active charcoal filters (Optional)
also be washed in a dishwasher. In this case,
it is advisable to stack them vertically to avoid
food residues to stick to them.
metallic surface (blackening it), although this will
not affect its fat retention capacity.
them onto the kitchen hood.
Lamps
exclusively for the illumination of the cooking
area.
areas
Solution
Connect the mains cable to the
Provide current to the network.
Change or clean the active
charcoal and/or metal filters.
Remove the obstruction.
Change the lamps.
Tighten the lamps.
network.