Changing The Batteries - Silvercrest homematic HmIP-SWDM-B2 Bedienungsanleitung Und Sicherheitshinweise


Mark the screw holes for the magnetic contact (D) or, if
necessary, the spacer (E) on the window (see Figure 6).

If fixing the device onto hard substrates, pre-drill with a 1.5 mm
drill (this is not necessary for soft substrates).

Hold the bracket of the electronic unit in the desired mounting
position and screw in both countersunk-head screws (2.2 x 16
mm) through the screw holes (see Figure 6).

Insert the electronic unit into the bracket.

Hold the back of the magnetic contact or the spacer in the
desired mounting position and screw in both countersunk-head
screws (2.2 x 13 mm) through the screw holes (see Figure 6).

Place the magnet in the back bracket and insert the back into the
housing of the magnetic contact.
When using the spacer, you can simply put the magnetic
contact on the spacer after mounting.

10. Changing the batteries

If an empty battery
Section "11.4 Error codes and flash sequences"), replace the used
batteries with two new type LR03/Micro/AAA batteries. When doing
so, observe the correct polarity of the batteries.
is displayed in the app or on the device (see
HmIP-SWDM-B2
English - 51