Teaching In The Device Onto The Access Point - Silvercrest homematic HmIP-SWDM-B2 Bedienungsanleitung Und Sicherheitshinweise

HmIP-SWDM-B2
device onto the access point, configuration is carried out using the
SilverCrest Smart Home app; when teaching in directly, configuration
is carried out on the device.

9.1.1 Teaching in the device onto the access point

Firstly, set up your access point via the SilverCrest Smart
Home app to enable use of other SilverCrest Smart Home/
Homematic IP devices in the system. More detailed
information regarding this can be found in the operating
instructions for the access point.
You can teach in the device both onto the access point and
on the Homematic CCU2/CCU3 central control unit. You
can find out more about this in the Homematic IP user guide
(available in the "Service" section at:
www.homematic-ip.com).
To enable the window and door contact to be integrated into your
system and to allow it to be controlled via the SilverCrest Smart Home
app, it must be taught in onto the access point.
To teach in the window and door contact onto the access point,
proceed as follows:

Open the SilverCrest Smart Home app from your smartphone.

Select the "Teach-in device" menu item.

Release the electronic unit (B) from the bracket (A) by sliding the
electronic unit upwards and removing it from the front (see Figure
2).
44 - English