Operation - Bosch Indego XS 300 Installationsanleitung

8

Operation

Set the height of cut for the grass.
8.1
It is recommended to start at a higher setting and then gradually reduce the level as the
wire disappears under the grass. This will prevent your Indego cutting the wire.
Note: the Indego is designed to cut small pieces of grass (5 mm) that drop down and
fertilise the soil.
Avoid mowing at night.
8.2
To reduce the chances of encountering wild animals and pets during operation, avoid using the machine during dusk or
dawn hours. For connected mowers use the Bosch Smart Gardening App to avoid this. Alternatively, for non-connected
mowers use the mower schedule.
LogiCut Intelligent Cutting – How your Indego cuts efficiently.
8.3
Your Indego is not only efficiently mowing your lawn in parallel lines. In order to leave a beautiful lawn, and to reach difficult
areas, your Indego will also change the direction of the lanes every time that it has finished a full cut of your lawn. So the
next time it starts again it will start in a different direction but always keeping the parallel lanes and its efficiency.
!
Allow the mower to run for 3 full cuts to cover the whole lawn area.
Cutting lawn area without docking station (Type B):
8.4
1. With the mower in the docking station, select Settings, Mowing mode and Mow without dock.
2. Enter PIN.
3. Carry the fully charged Indego to the additional area and place it on the lawn.
4. Press the key and follow the instructions on the display. The mower will operate in a random mowing pattern using
this mode.
5. The Indego will mow until it runs out of battery, displaying "Done, place in dock". Battery run time will vary depending
on your model and lawn conditions. Please see the product specifications table.
6. Return your Indego to the docking station.
Your Indego will continue its calendar/schedule as normal (if you have set this up), once it has recharged.
44
Cutting in separated lawn areas (Type C).
8.5
1. Switch off your Indego.
2. Carry your Indego to the docking station of the lawn area you want to mow.
3. Switch on your Indego and place it in the docking station.
Your Indego will automatically recognise the lawn area and will load the correct map.
Now your Indego is ready to mow.
If you have set up the calendar, your Indego will follow the calendar setting regardless of the lawn area it is in.
SpotMow.
8.6
SpotMow is intended for mowing small areas that require special treatment without having to mow the whole lawn, such as
the area under a piece of garden furniture that has been removed. To use SpotMow you first need to activate it whilst your
Indego is sitting in its docking station. Please select 'Settings' > 'Mowing mode' and then follow the instructions on the
display.
Indego needs to be positioned at the lower left corner of the area you intend to mow. After completion, please follow again
the instructions shown on the display.
The final mown area depends on the lawn conditions and may not be an exact square.
Border cutting.
8.7
When the BorderCut function is available (see specification table at the beginning) your Indego will start cutting the border
before commencing a new full cut of the lawn to ensure that the edges are tidy. If your model features the option to change
the setting of the BorderCut (Indego M/M+700), you can adjust the settings via the menu under 'Settings > Mowing mode'.
Battery charging.
8.8
Your Indego features intelligent battery management which optimises the use to maximise its life time.
Whilst mowing, your Indego will automatically return to the docking station when it needs to recharge. After finishing a
mowing session or whilst sitting in the docking station, your Indego may not directly do this. Your Indego will sit in the
docking station without recharging if the battery charge is above the threshold. If the battery charge falls below the
threshold, charging will resume. This will maintain the health of your Indego battery.
Connected models need to maintain the communication with the mobile network. As this is powered by the battery,
connected models automatically recharge more frequently whilst sitting in the docking station compared to non-connected
models.
GB
45