Installation Preparation - Bosch Indego XS 300 Installationsanleitung

1

Installation preparation

To ensure that all installation steps are successfully completed, as preparation,
we recommend that you use the last page of the booklet to sketch your lawn
area.
3 30 cm
< 135 cm
30 cm
30 cm 30 cm
4
1
2
< 135 cm
5 cm
<15%
30 cm
3
30 cm
> 135 cm
30 cm
Example:
Type A: Single lawn.
A single lawn area where narrow passages are at least 135 cm wide.
30
1.▶ Identify and mark location of the power socket.
2.▶ Decide where you will place the docking station
(close to power socket).
3.▶ Identify and mark any objects that are to be
excluded from the cutting area such as trees,
flower beds, ponds, slopes >27%. These will
need to be excluded with the perimeter wire
during the installation.
4. ▶ Identify and mark any narrow passages with
less than 135 cm.
3
>27%
0 2 4 6 8
Type B: Multiple lawn areas.
Your lawn is divided into several lawn areas separated by passages less than 135 cm or separated by steps or gravel
where the mower cannot travel through.
All lawn areas can be connected with one perimeter wire. Additional lawn areas should be no larger than 40 m² (XS),
45 m² (S/S+) or 50 m² (M/M+).
The docking station is positioned in the main area. You will need to carry the mower from one area to another.
Your Indego will navigate the additional area in a random mowing pattern. Only areas with a docking station are cut in
parallel lines using LogiCut Intelligent Cutting.
Type C: Separated lawn areas.
Your garden is divided into 2 or 3 separated lawn areas (e.g. front and back garden).
If your lawn areas cannot be connected with one perimeter wire or if the additional lawn area is bigger than 40 m² (XS),
45 m² (S/S+) or 50 m² (M/M+), you will need an additional docking station for each lawn area.
You will need to carry the mower from one area to another.
GB
31