Bosch Indego XS 300 Installationsanleitung Seite 20

Obstacle / Needed
Why
Object Type Space
Corners > 45° Your Indego needs this space to turn.
A loose wire might be cut or become a trip
hazard. Therefore, ensure the wire is taut.
If you can place two fingers under the wire, it
Between 2 pegs 75 cm
is not taut enough. Corners, bends, or bumpy
areas may require an increased number of pegs
to be used.
Whilst driving down a slope, Indego is at a
Slope on the higher risk of driving over the perimeter wire.
< 15%
perimeter wire Therefore the slope at the perimeter wire
should not be more than 15%.
Start laying the perimeter wire from the
5.1
docking station in an anti-clock wise direction.
Pull the wire from the coil. Tauten and fix it with one peg next to the docking
station.
Ensure the wire is straight and in line with the cable duct underneath the
docking station for 1.5 m.
If the wire is not straight and in line with the docking station, the Indego will
not work and you will need to re-lay the wire.
If you place the docking station in a corner, you may need to change
the settings of your Indego. Please refer to Chapter 7: Mapping for
further information.
Lay the perimeter wire around the lawn area.
5.2
Ensure the wire is taut before placing the next peg.
(if you can place two fingers under the wire, it is not taut enough).
In this case tauten the perimeter wire and increase the number of pegs (if needed).
Please consider the wire layout around the obstacles you want to exclude (point 5.3)
and/or additional areas (point 5.4).
38
Marking objects that you want to exclude
5.3
e.g. Trees, flower beds, ponds, slopes.
Example
This will prevent your Indego colliding with objects, or going straight into them.
There are two ways to exclude objects from the cutting area. When excluding objects, all given distances in section 5 needs to be
considered.
> 45°
► A: If the distance between the outer perimeter wire and the perimeter wire around the object is at least 75 cm:
• Run the perimeter wire to the object.
• Do not fully immerse the pegs into the lawn, as these will be used when the perimeter wire is returning from the object.
• Lay the perimeter wire around the object in a clockwise direction, whilst respecting the required distance of 30 cm to the
object.
• Return to the outer perimeter wire by placing the wire under the same side of the peg. The parallel wires need to be as
close as possible to each other to make them undetectable to your Indego.
► B: If the required distance of at least 75 cm between wires cannot be ensured, the exclusion needs to be done as shown
in variant B.
When going around objects, it is recommended to use more pegs.
If the perimeter wire is laid out in the wrong direction (as shown in image C) your Indego will receive incorrect signals from the
75 cm
perimeter wire and will not operate as expected.
 
> 15% < 15%
You can use connectors to connect/add wire (D) to your original perimeter wire layout. Alternatively, you can also use
connectors to add an inner boundary e.g. a flower bed (E) or other items which need to be wired out in your lawn. Follow the 4
steps below for each case.
< 75 cm
B
A
> 75 cm
D
E
GB
C
<1 cm
3 cm 3 cm
3 cm 3 cm
39