Correct Disposal Of This Product - ECOVACS DEEBOT N8+ Bedienungsanleitung

To satisfy RF exposure requirements, a separation
distance of 20 cm or more should be maintained between
this device and persons during device operation.
To ensure compliance, operations at closer than this
distance is not recommended. The antenna used for this
transmitter must not be co-located in conjunction with any
other antenna or transmitter.
To disable Wi-Fi module on DEEBOT, power the robot ON.
Place the robot on the Auto-Empty Station making sure
the Charging Contacts on DEEBOT and the Auto-Empty
Station Pins make a connection.
Press and hold the AUTO Mode Button on the robot for
20 seconds until DEEBOT emits 3 beeps.
To enable Wi-Fi module on DEEBOT, power the robot OFF
and then power ON. The Wi- Fi module is turned on when
DEEBOT is restarted.
EN 4
Class II
Short-circuit-proof safety isolating
transformer
Switch mode power supply
For indoor use only
Direct current
Alternating current
For EU Countries
For EU Declaration of Conformity information, visit https://
www.ecovacs.com/global/compliance

Correct Disposal of this Product

This marking indicates that this product should not be
disposed of with other household waste throughout
the EU. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material
resources. To recycle your used device, please use the
return and collection systems or contact the retailer where
the product was purchased. They can safely recycle this
product.