Epson TM-J7000 Benutzerhandbuch Seite 14

English
Installing or Replacing Roll Paper
CAUTION:
Be careful not to insert your fingers into the paper exit. The cutter blade is
installed inside the paper exit and you might be injured.
See illustration D.
CAUTION:
Be sure to use roll paper that meets the specifications.
Follow these steps to install or replace paper:
1. Make sure the printer is on.
2. Open the roll paper cover by pressing the cover open button. See
illustration E.
3. Remove the used roll paper core if there is one.
4. Put the roll paper inside the printer in the correct direction, as shown in
illustration F.
5. Pull out the leading edge of the roll paper; then close the roll paper cover until
it is firmly locked by pushing the top of the cover.
6. The printer will automatically feed the roll paper to remove any slack in the
paper.
Note:
Do not open the roll paper cover during printing or paper feeding.
Inserting Slip Paper
Note:
Be sure the paper is flat, without curls, folds, or wrinkles.
Use only single sheet paper. Do not insert any multiple sheet paper, as this may cause a
paper jam.
Because the printer is an inkjet printer, pressure sensitive copy paper cannot be used.
To prevent jams, roll paper must be installed even for printing on slip paper.
Be sure to insert a slip with the right side of the paper against the right side of the
paper guide as far as it will go, as shown in illustration G. See the label
instructions attached to the printer as a guide.
Installing or Replacing an Ink Cartridge
CAUTION:
Usage:
Do not disassemble the cartridge. The ink can permanently stain clothing.
Do not refill ink cartridges. Spills can result, causing damage to the printer.
Do not remove the cartridge except to replace it or to prepare the printer
for shipment. Otherwise, ink may be wasted and the life of the ink cartridge
may be reduced.
6 TM-J7000/J7100 – TM-J7500/J7600 User's Manual