Siemens LB53NAA30 Gebrauchs- Und Montageanleitung Seite 26

en Installation instructions
Make the cut-out for the exhaust pipe.
2.
Preparing the appliance
Remove the grease filters.
1.
To avoid causing damage, do not bend the grease
filters.
Remove the panel. To do this, press the two latch-
2.
ing mechanisms at the same time
the panel ⁠ .
Fit the one-way flaps on the air outlet and click them
3.
into place.
Note: If the fitted unit is no longer accessible after the
appliance is installed, remove the side locking mechan-
ism. To do this, undo the fastening screws and secure
these to the appliance's housing.
26
Installing the appliance
1.
and remove
2.
3.
4.
5.
ATTENTION!
If you already have a cut-out for a previous model of
the same brand, the latching mechanism does not
engage.
Secure the appliance so that it does not fall
▶
down and become damaged.
Place the appliance in the cut-out
New cut-out
Cut-out for a previous model
Tighten the fastening screws
If you are using a cut-out for a previous model, you
may not be able to use the side screws
Secure the panel.
Push the panel upwards until the latching mech-
‒
anism engages.
Fit the grease filters.
To avoid causing damage, do not bend the grease
filters.
Insert the mains plug into the protective contact
socket.
⁠ .
⁠ .
⁠ .