Avoiding Material Damage; Environmental Protection And Saving Energy; Disposing Of Packaging - Siemens LB53NAA30 Gebrauchs- Und Montageanleitung

WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric
shock.
▶ Before cleaning, pull out the mains plug or
switch off the fuse in the fuse box.
▶ Do not use steam- or high-pressure clean-
ers to clean the appliance.
2 Avoiding material damage
ATTENTION!
Condensate may cause corrosion damage.
To prevent condensation from building up, switch on
▶
the appliance during cooking.
If moisture gets into the controls, this may result in
damage.
Never clean controls with a wet cloth.
▶
Incorrect cleaning damages the surfaces.
Follow the cleaning instructions.
▶
Do not use harsh or abrasive detergents.
▶
Clean stainless steel surfaces in the direction of the
▶
finish only.
Never clean controls with stainless steel cleaners.
▶
3 Environmental protection and saving energy
3.1 Disposing of packaging
The packaging materials are environmentally compat-
ible and can be recycled.
Sort the individual components by type and dispose
▶
of them separately.
3.2 Saving energy
If you follow these instructions, your appliance will use
less power.
Ensure that there is sufficient ventilation when cook-
ing.
¡ The appliance works more efficiently and with fewer
operating noises.
WARNING ‒ Risk of explosion!
Highly caustic alkaline or highly acidic clean-
ing agents in conjunction with aluminium parts
in the interior of the appliance may cause ex-
plosions.
▶ Never use highly caustic alkaline or highly
acidic cleaning agents. In particular, do not
use commercial or industrial cleaning
agents in conjunction with aluminium parts,
e.g. grease filter on extractor hoods.
Condensation that flows back in may damage the ap-
pliance.
The air extraction duct must be installed with a
▶
gradient of at least 1° from the appliance.
If you put incorrect stress on the design elements, they
may break off.
Do not pull design elements.
▶
Do not place objects on the design elements or
▶
hang objects from them.
There is a risk of surface damage if you do not peel off
the protective film.
Remove the protective film from all parts of the ap-
▶
pliance before using for the first time.
If one lamp is defective, this may overload the remain-
ing lamps.
Replace any defective lamps.
▶
Adjust the fan speed to the amount of steam pro-
duced during cooking.
¡ The lower the fan speed, the less energy is con-
sumed.
If cooking produces large amounts of steam, select a
higher fan speed in good time.
¡ The odours are distributed around the room less.
Switch the appliance off when you are not using it.
¡ The appliance does not consume any energy.
Switch off the lighting if you no longer require it.
¡ The lighting does not consume any energy.
Clean or replace the filters at regular intervals.
¡ The effectiveness of the filter is retained.
Put the cooking lid on.
¡ The cooking vapours and condensation are re-
duced.
Avoiding material damage en
17