Accessories And Replacement Parts; What If There Are Problems; Disposal; Technical Specifications - Beurer HK 37 To Go Gebrauchsanweisung

IMPORTANT
Place the powerbank (4) in a dry, dust-free and cool place, away from direct sunlight. The powerbank
should be charged once a year to retain its capacity.

9. Accessories and replacement parts

For replacement parts and additional items visit www.beurer.com or contact the corresponding service ad-
dress in your country (according to the service address list).
Replacement parts and additional items are also available from retailers.
• Powerbank (item no. 163.296)
• Charging cable (item no. 163.297)
USB is a registered trademark of USB Implementers Forum Inc.
®

10. What if there are problems?

Problem
The LED display of the On/Off button (2)
on the heat pad (1) and the white LED
display on the powerbank (4) do not light
up when:
– the powerbank is connected to the heat
pad and
– the On/Off button has been pressed.
The LED display of the On/Off button (2)
on the heat pad (1) and the white LED
display on the powerbank (4) do not light
up when:
– the fully charged powerbank is con-
nected to the heat pad and
– the On/Off button has been pressed.

11. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of its
service life. Dispose of the device at a suitable local collection or recycling point in your country.
Dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic
Equipment). If you have any questions, please contact the local authorities responsible for waste
disposal.
The empty, completely flat batteries must be disposed of through specially designated collection boxes,
recycling points or electronics retailers. You are legally required to dispose of the batteries.

12. Technical specifications

Powerbank:
Operating temperature: 0 to +45°C
Storage temperature: -10°C to +45°C
Recommended storage temperature: -10°C to +25°C
For technical data, see the type plate label on the heat pad and on the powerbank.
Cause
The powerbank has been fully run
down.
There was a SAFETY SWITCH-OFF
due to a fault in the heat pad.
The heat pad or the powerbank is
faulty.
19
Solution
Charge the powerbank.
Allow the heat pad to cool
down to room temperature
and switch it on again.
Send the heat pad and the
powerbank for servicing.