Cleaning And Care - Beurer HK 54 Gebrauchsanleitung

4.2 Putting into operation
First check that the switch is connected to the heating pad at the plug-in connection. Plug the
power cord into the mains outlet.
4.3 Selecting temperature
The fastest way to heat up the heating pad is to first set the switch to the highest setting. A
lower setting can be selected later if required.
After switching on the heating pad, the setting starts flashing briefly, while the heating pad
conducts a self-test. Then the setting remains illuminated continuously.
We recommend the lowest temperature setting for extended use of the heating pad.
4.4 Temperature settings
Setting: 0 Off
1 Minimum heat
2 Medium heat
3 Maximum heat
4.5 Automatic switch-off function
This heating pad is equipped with an automatic shut-down function which stops
the heat supply approx. 90 minutes after switching on the pad. The illuminated
function display then starts to flash. To operate the heating pad again, you must
first set the switch to zero. After about 5 seconds, it can be switched on again.
If the heating pad is no longer used after the timed switch-off, it should be
switched off (setting "0") or else unplugged from the mains.
4.6 Fast heating
These heating pads have a fast heating function which allows them to heat up
quickly within the first 10 minutes.

5. Cleaning and Care

Before cleaning the heating pad, always unplug it from the mains.
Smaller stains on the heating pad can be removed using a cloth or
moist sponge together with a little liquid detergent for delicate fabrics
if necessary. Do not use any cleaning agents containing solvents on
the appliance.
Please note that the heating pad should not be dry-cleaned, wrung
out, machine-dried, pressed or ironed.
Before washing, first remove the plug-in connection together with the switch from the heating
pad (see illustration). Set the washing machine to a gentle washing cycle at 40 °C.
For ecological reasons, we recommend that the heating pad is only washed together with
other textiles. Use a washing powder or liquid for delicate fabrics and dose it according to the
manufacturers instructions.
Please note that excessive washing will wear out the heating pad. For this reason, the heating
pad should only be machine-washed a maximum of 10 times throughout its entire life.
When drying the heating pad, do not use clothes pegs or anything similar, and never
switch the heating pad on to dry it!
Do not reconnect the switch to the heating pad until the plug-in connection and the heat-
ing pad are completely dry.
10