Messages - Sony DSX-A416BT Bedienungsanleitung

The "Sony | Music Center" application is
automatically disconnected when the
display switches to [IPD].
 The "Sony | Music Center" application on
iPhone/iPod does not support iPod
playback.
– Change the source of the unit to other
than [IPD], then establish the "Sony |
Music Center" connection (page 16).
The "Sony | Music Center" connection is
automatically disconnected when the USB
mode of the unit is changed to
[ANDROID].
 The Android smartphone is not
supporting playback in Android mode.
– Set the USB mode of the unit to [MSC/
MTP], then establish the "Sony | Music
Center" connection (page 16).

Messages

The following messages may appear or flash
during operation.
INVALID
 The selected operation could be invalid.
 [USB MODE] cannot be changed during
iPod playback.
READ
 Wait until reading is complete and
playback starts automatically. This may
take some time depending on the file
organization.
(underscore): The character cannot be
displayed.
For USB device playback:
HUB NO SUPRT: USB hubs are not
supported.
IPD STOP: iPod playback has finished.
 Operate your iPod/iPhone to start
playback.
28
GB
NOT SUPPORT - ANDROID MODE
 A USB device not supporting AOA
(Android Open Accessory) 2.0 is
connected to the unit while [USB MODE] is
set to [ANDROID].
– Set [USB MODE] to [MSC/MTP] (page 19).
USB ERROR
 Connect the USB device again.
USB NO DEV
 Make sure the USB device or USB cable is
securely connected.
USB NO MUSIC
 Connect a USB device containing playable
files (page 23).
USB NO SUPRT
 For details on the compatibility of your
USB device, visit the support site on the
back cover.
OVERLOAD: The USB device is overloaded.
 Disconnect the USB device, then press SRC
to select another source.
 The USB device has a fault, or an
unsupported device is connected.
For RDS operation:
NO AF: No alternative frequencies.
 Press  (SEEK –/+) while the
program service name is flashing. The unit
starts searching for another frequency
with the same PI (program identification)
data ([PI SEEK] appears).
NO PI: No program identification. The
selected station has no PI (program
identification) data.
 Select another station.
NO TP: No traffic programs.
 The unit will continue searching for
available TP stations.