FUTABA T18SZ Einbauanleitung Seite 8

Einbauanleitung/Manual Rev. 3
Foreword
Hand transmitters are fully equipped with all switches and do not have any additional
free connection options for joystick switches. This means that in any case, we must
place the connection cables of the joystick switches on connections of existing
switches and replace them.
In this manual, the two new stick switch replace the existing switch groups SG / SH
and SE / SF in a T14SG.
The two switch groups have small, individual circuit boards in which the existing
cable trees are firmly soldered with crimped plugs. The other end of these cable trees
goes to the main board.
Open the housing with the example of the T14
Open battery compartment, unplug battery, remove battery.
Front cover
Tilt the antenna forwards
Open 2 cap screws (2.5 mm)
Remove the front cover
Remove side cover from the top of the transmitter, then remove it from the transmitter
bottom
Housing base
Remove the four crossbars of the floor.
Remove the transmitter base
Note: The lower rubber strips in the transmitter base remain in the ground
info@rctechnik.de Seite 8