FUTABA T18SZ Einbauanleitung Seite 10

2. stick fit
The sticks are provided at the base with a knurl with outer diameter 3.7 mm.
With this measure they fit in most systems without much effort in the plastic
receptacles.
In systems with smaller holes, you can drill out the stick holder with a 3.7 mm
drill at low speed and then polish it with 3.8 mm by hand.
For small dimensional differences you file the knurled part until the stick can
be press-fit with slight pressure.
During pressing, you should not press on the outside of the system, but from
the inside (where the cable run) with a thin tube pressing against it.
For systems with greater intake, the stick can be glued with 5min. Epoxy
Please do not force it!
3. Cable laying (Example FX-30):
This technique is available for the transmitter without through hole of 1.5 mm.
Wire for wire put through the hole.
It's better than you think. A pointed tweezers is helpful.
info@rctechnik.de
Einbauanleitung/Manual Rev. 3
Seite 10