FUTABA T18SZ Einbauanleitung Seite 11

Einbauanleitung/Manual Rev. 3
Tip:
To threading the cables easier, use a slightly thicker wire and push through
the opening until he looks through the stick unit. On this wire you solder the
leads of the stick switch and pull it completely through the stick unit. At 4 and 5
cable to the stick switch you should use this technique with two wires and a
lead part on the left and right part of the potentiometer over.
Sort them so that there is no fraying or kinks in the cable. Shrink as guides
may be used as a tool (not to be shrunk).
Secure the cables so that they can join in all movements of the stick.
info@rctechnik.de Seite 11