Filling The Water Tank; Remote Control - be cool BCP5AC2101F Bedienungsanleitung

FILLING THE WATER TANK

Before you fill the water tank, make sure that the water tank plug on the bottom
side of the AirCooler is firmly pushed into the water tank opening so no water
Furthermore, please note the following:
1. Open the water inlet on the front of the air cooler.
2. Carefully fill the water tank with clean water, using a watering can or similar container
Pay attention to the fill level on the front of the water tank:
MIN mark  The water tank must be filled via the MIN mark for the pump to work
properly
MAX mark  The water tank must not be filled via the MAX mark, otherwise water
could get inside the appliance and damage electronic parts.
3. Make sure that the appliance is not damp or wet from the outside and wipe it down if
necessary.
4. Close the water inlet flap.
PREPARING REMOTE CONTROL – INSERTING OR REPLACING BATTERIES
Please follow the steps below to make it operate correctly:
Initial Operation:
1. To use the remote control for the first time, remove the plastic cover from the battery
compartment on the back of the remote control.
Battery replacement:
1. To operate the remote control, please insert the button cell provided.
2. To do so, pull out the battery holder on the back of the remote control and insert the
battery:
3. Please always pay attention to the polarity markings (+/-) on the battery and
the battery holder:
4. Then insert the battery holder back into the remote control.
The buttons of the remote control are labelled as shown in the illustration below. All
functions of the remote control work identically with the manual operation on the
ATTENTION
leaks.

REMOTE CONTROL

NOTE
appliance.
Seite 18 von 24