Auto Swing; Sleep Mode; Water Drainage - Beko BP109C Bedienungsanleitung

6 Operation introduction
Timer Off setting:
- When the air-conditioner On, press "Timer" button and select a desired Off time through the
temperature and time setting buttons.
- "Preset Off Time" is displayed on the operation panel.
- Off time can be regulated at any time in 0-24 hours.

6.7 Auto swing

- This function could be only realized through Homewhiz app.

6.8 Sleep mode

- While in cooling mode, press the Sleep key to set the temperature. It increases 1°C after an hour
and at most increases 2°C after 2 hours.
- While in heating mode, press the Sleep key to set the temperature. It decreases 1°C after an hour
and at most decreases 2°C after 2 hours.
- Press the Sleep key again can cancel the setting.

6.9 Water drainage

Water full alarm
- The inner water tray inside the air-conditioner has one water level safety switches, it controls
water level. When water level reaches an anticipated height, the water full indicator lamp lights
up. (If water pump is damaged, when the water is full, please remove the rubber blockage at the
bottom of unit, and all water will drain outside.)
Continuous drainage
- When you plan to leave this unit unused for a long time, please remove the rubber blockage from
the drainage hole at the bottom of unit, and connect a drain hose to the lower fixing clip. All the
water in the water tank will drain outside.
- You can drain the water as the above when the unit working at the heat mode and dehumidifying
mode.
- If water pump is damaged, continuous drainage can be used, and under this condition, the water
pump is not activated. The unit can also work well.
If water pump is damaged, intermittent drainage can also be used. Under this condition, when the
water full indicator lamp lights up, please connect a drain hose to the lower fixing clip, then all the
water in the water tray will be drained outside. The unit can also work well.
38 / 340 EN
Local Air-conditioner / User Manual