Jaga BRIZA 22 Handbuch Seite 26

03
5
6
1. Place the screws of the device(5-8) and let them stick out 1 cm.
2. Place the device in the correct position.
3. Tighten the screws.
05
1
2
Install the support bolts in the back plate.
Let the bolts stick out 1 cm.
07
Ceiling mounted model: place the middle screw and tighten!
26
04
7
8
Connect the device hydraulically.
can prevent normal drainage.
pipes, fix the unit (back plate) to spacers (e.g. threaded rods).
06
3
4
1. Mount the casing. Make sure the mounting holes are in line with
the support bolts.
2. Fix the casing by tightening the support bolts.
08
Install the grille. Put the screws in the mounting holes.
JAGA N.V. | BRIZA 22 - CASING | MANUAL | 2021.02.04 | V.02
Make sure that the condensation water is drained quickly.
Keep the condensation drain clean and remove obstacles that
If there is not enough space in the ceiling for the hydraulic
Ideally, the air should be blown into the room.