IBIZA LIGHT SCAN500RGB Bedienungsanleitung Seite 7

MANUAL - SCAN Laser Systems
INSTALLING THE BATTERIES IN THE REMOTE CONTROL
•
Place the remote face down on a flat surface.
•
Push the compartment cover into the direction of the arrow.
•
Slide the battery compartment open.
•
Remove the old battery and install the new one (CR2032) with the plus (+) symbol facing up.
•
Gently slide the battery compartment closed. It locks automatically.
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in accordance with
your local regulations..
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
WARNING :Do not swallow the battery. Danger of chemical burns. Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact immediately a doctor.
REMOTE CONTROL
•
[INTR] key: Enter the mix mode built-in.
•
[DMX] key: Professional DMX mode.
•
[E-DMX] key: easy DMX mode.
•
[1-9] key: digital number from 1 to 9
- In the built-in mix mode, press the [1-9] button to enter the scene playback mode. The
number entered is the scene
- When the built-in sequence is played, press the [1-9] button to select the serial number.
- In DMX mode or E- DMX mode, press the digital button to set the address code.
- In the setting mode, you can select the projection range when setting the projection angle.
•
[+][-] key:
- In the scene playback mode, press this key to adjust the scene number.
- Press this key to adjust the serial number in the sequence play mode.
- In DMX or E- DMX mode, press this key to adjust the address code.
- When setting mode, press this key to adjust the setting item.
•
[SET]key:
- When the system is not in the set state, press 5 times to enter the system setting state.
- When the system is in the setting state, press this key to exit the system setting state.
•
[RGB] key:
- Press this key to toggle the pattern colour. When the colour is changed, the display will temporarily display
the currently set colour.
- This setting is set to temporary, and the system will return to the colour state (CLR) after the shut-down is
restarted.
•
[SEQ] key: Press this key to enter the sequence playback mode in built-in mode.
•
[B-Out] key: Press this key to turn off the laser output.
•
[Sound] key:
- In the built-in mode, press this key to set or cancel the voice.
- When setting a mixed sequence, you can select or cancel a sequence.
- You can select or cancel the mirror when setting the graphic X mirror, the graphic Y mirror, and the XY for the
graphic.
- You can select or cancel the remote control when setting the remote control function.
•
[ENTER] key: When entering a number, the value to be entered is less than 100, press this key to speed up the
digital input.
IMPORTANT NOTE: Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local au-
thorities or your dealer about the way to proceed.
www.ibiza-light.com
EN
7