IBIZA LIGHT SCAN500RGB Bedienungsanleitung Seite 3

MANUAL - SCAN Laser Systems
•
Secure fixture to fastening device using a safety chain.
•
Maximum ambient temperature (Ta) is 104° F (40°C). Do not operate the fixture at temperatures higher than
this.
•
In the event of a serious operating problem, stop using the unit immediately. Never try to repair the unit by
yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the near-
est authorized technical assistance centre. Always use the same type of spare parts.
•
Don't connect the device to a dimmer pack.
•
Make sure the power cord is never crimped or damaged.
•
Never disconnect the power cord by pulling or tugging on the cord.
•
Don't expose your eyes to the light source while it is on.
DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
LASER EMISSION DATA
As measured under IEC measurement conditions for classification.
Laser Classification ............................................................................................................................ Class 3B
Green Laser Medium ....................................................................................................................DPSS 532nm
Red Laser Medium ...................................................................................................LD GaAIAs 638nm,typical
Blue Laser Medium .................................................................................................. LD InGaN 445nm, typical
Beam Diameter .................................................................................................................. <3mm at aperture
Divergence(each beam) ..................................................................................................................<1.3 mrad
Divergence(total light) .....................................................................................................................<1.3mrad
Transverse Beam Mode ......................................................................................................................... TEM00
Cooling ................................................................................................................................ TEC & Fan Cooling
Scanning .............................................................................................................. High speed scanner 25kpps
LASER POWER
SCAN500RGB : ........................................................100mW-G-532nm+200mW-R-650nm+200mW-B-445nm
SCAN1100RGB: .......................................................200mW-G-532nm+300mW-R-638nm+600mW-B-445nm
SCAN2000 RGB: ....................................................500mW-G-532nm+500mW-R-638nm+1000mW-B-445nm
SCAN1100PINK: ..................................................................................... 500mW-R-638nm+600mW-B-445nm
SPECIFICATIONS
Mains Input: ....................................................................................................100-240V~ 50/60Hz, total 30W
Fuse: ............................................................................................................250V 2A slow blow (20mm glass)
Menu mode: .............................................................................Auto, music, DMX512, Master/slave, ILDA, IRC
Laser Classification: ........................................................................................................................... Class 3B
Laser Safety Standard:.......................................................................................................... EN60825-1:2014
Condition Temperature: .................................................................................................................. 10℃~40℃
DMX channels ..........................................................................................................................5 / 34 channels
Dimensions ......................................................................................................................246 x 211 x 105mm
Weight:.................................................................................................................................................... 3.5kg
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. Always ensure that the structure to which you are attaching the unit
is secure and able to support a weight of 10 times of the unit's weight. Also always use a safety cable that can
hold 12 times the weight of the unit when installing the fixture.
DMX512
1. Install the units in a suitable position (laying or appending).
2. Use standard XLR microphone cable chain your units together via the XLR connector on the rear of the units.
For longer cable runs we suggest a terminator at the last fixture.
3. Assign a DMX address to each the unit.
4. Turn on all units' power, the units begins reset, then the unit begins working.
5. Use DMX console to control your units.
INSTALLATION
www.ibiza-light.com
EN
3