LD Systems DQOR Serie Bedienungsanleitung Seite 8

2
2
Firmly secure the wall mounting plate with the terminal block at the top using suitable screws on a wall sufficiently capable of supporting the
load. For speaker cables laid under plaster, the corresponding cable must be inserted through the central cable bushing prior to securing the wall
mounting plate. Now connect the speaker cables to the corresponding contacts of the terminal block.
3
Slide the speaker with the wall bracket from above onto the wall mounting plate in such a way that the contacts on the speaker slide into the
guide grooves of the sliding contacts of the wall mounting plate and the retaining hook engage into the corresponding recess.
4
Using the ball joint in the wall bracket, the speaker can be turned to the vertical or the horizontal position (turning in both directions by
maximum 180°). Then tilt and swivel the speaker into the desired beam direction
clockwise tightly onto the associated thread until the marking on the union nut matches either the marking on the retaining hook
D
marking on the wall mounting plate
4
D
5
Secure the ball joint and the dome-shaped union nut from moving by tightening the safety screw in the union nut clockwise using the hex key
that is included . When you do this, make sure that the screw is fully countersunk.
G
5
8
F to ensure that the safety screw can also engage into one of the two through-holes in the collet.
C
G
3
. Now fix the speaker by screwing the dome-shaped union nut
C
E
F
E
or the