Roger CTRL Anweisungen Und Hinweise Für Den Installateur Seite 79

photocell is cleared.
Photocell (FT) mode with barrier closed
N.B.: this parameter is not visible if the value of parameter
If the photocell is obstructed, the barrier cannot open.
Enable close command 6 s after activation of photocell (FT)
N.B.: This parameter is not visible if
Disabled.
Enabled. When the photocell barrier FT is crossed, a close command is sent 6 seconds later.
Motor stop distance setting
The motor brake function is activated each time a stop is requested by a user command or by
activation of the photocells.
01= rapid braking/smaller stopping distance ...
10= gentle braking (soft-stop)/greater stopping distance (NOTE
N.B.: Available values may be limited by the setting for parameter
Installation position of barrier relative to gateway (seen from interior side)
SLAVE barrier recognises its position automatically.
N.B.: every time the installation position is changed by altering parameter
position data request message
Sensing edge NOT INSTALLED.
PARTIAL OPENING.
OPENING.
CLOSING.
STOP.
(1)
•
or
. Press the PROG key until
.
(1)
.
(1)
.
(1)
e
= , or
is set, and if value of parameter
.
appears on the display, then
.
(1)
or if = , , or .
= , or .
79