Commands and Accessories
7
or disabled by modifying the parameters
STOP command signal must be connected to the SLAVE controller.
N.A. (Normally Open) .
N.C. (Normally Closed).
CONTACT
11(+SC)
10(COM)
11(+SC)
13(COM)
11(+SC)
13(COM)
12(+LIGHTS)
13(COM)
14(+24V)
13(COM)
15(+ES)
17(COM)
16(+LAM)
17(COM)
18(COM)-19(LNA)-20(LNB)
18
19 20
DESCRIPTION
The function of the indicator lamp is determined by parameter
Set the parameter
to enable the test function.
that the contact changes state correctly.
reduce battery consumption (if batteries are used). Set
WARNING! If contact 11(SC) is used for the photocell test function or battery saving function, a
maly or for signalling battery supply anomaly (battery exhausted. (Fig. 9)
The voltage level of the battery can be set via parameter
NOTE
open; OFF = bar closed".
If par.
=
, the SC output of the SLAVE control unit provides instead an alarm signal relative
to the SLAVE barrier.
Input for connecting ALED series signal lights on boom (optional). 24 V DC 12W max
The function of the electric lock is determined by parameter
Vmedia=12Vdc, Vmax=40Vdc; see table "PRODUCT TECHNICAL FEATURES" on page 62
RS485 serial communication cable connection (3x0.5 mm
Connections.
• Connect the COM-LNA-LNB
SLAVE barrier.
•
(PED) is received.
• Set parameter
•
• All command signals, the photocells and the main STOP command must be connected to the
nected to the corresponding barriers.
• An auxiliary STOP command signal may also be connected to the SLAVE barrier. If not used,
jumper terminals 21(ST)-22(COM) on the SLAVE controller.
• All parameters except for
• The travel acquisition procedure must be performed for both barriers, after setting the param-
•
,
and
.
.
SC output, an error alert signal contact can be achieved at an
=
,
,
), the SC output of the SLAVE is of type "ON = bar
.
- max. length 30 m) for installation of
2
ACS/BA/60
,
and
.
11(SC).
or
. In the case of installa-
SC output of the
.
or later).
for the SLAVE barrier.
-
,
-
65