Maintenance And Adjustment; Error Messages - Opal OD5+ Anleitung

5.

Maintenance and Adjustment

5.1 Error Messages

LED Light
Beep
Ready Status
4 beeps
Red
twice
Red Red
None
(Flash) (Flash)
3 beeps
Red
twice
2 beeps
Red
twice
2 beeps
Red
twice
2 beeps
Red
twice
2 beeps
Red
twice
2 beeps
Red
twice
Schweiz - OPAL Associates AG - Motorenstrasse 116 - CH-8620 Wetzikon - Tel.: +41(0)44 931 12 22 - Fax: +41(0)44 931 12 20 - Email: info@opal-holding.com - www.opal.ch
Deutschland - OPAL Associates GmbH - Am Vögelisberg 5 - D-78479 Reichenau - Tel.: +49(0)7534 999 56 0 - Fax: +49(0)7534 999 56 99 - Email: info@opalgmbh.de - www.opalgmbh.de
Österreich - OPAL Associates GesmbH - Donaufelderstrasse 101/2/8 - A-1210 Wien - Tel.: +43(0)1 270 03 13 - Fax: +43(0)1 270 03 15 - Email: info@opalgmbh.at - www.opalgmbh.at
Frankreich - OPAL Associates SA - Avenue des Boveresses 54 - CH-1000 Lausanne - Tel.: +41(0)21 653 95 00 - Fax: +41 (0) 21 653 95 02 - Email:info@opal-holding.com - www.opalsa.ch
Dänemark - OPAL Associates ApS -
Melskov Alle 6
Weitere Standorte: München, Hamburg, Frankfurt, Darmstadt, Bregenz, Lyon - www.opal-holding.com
Description
Print head is not firmly closed.
The temperature of the print
head is too high.
Ribbon is not installed, and
printer shows error message.
Ribbon is used up or ribbon
supply shaft is not moving.
Unable to detect paper.
Paper used up.
Abnormal paper feed.
Memory is full; printer will print
out "Memory full."
Can't find the file; printer will
print out "Filename can't be
found."
File name is repeated; printer
will print out "Filename is
repeated."
- DK-6100 Haderslev - Tel.: +45 7674 1510 - Fax: +45 7589 2733 - Email: info@opalaps.dk - www.opalaps.dk
User's Manual
Solution
Re-open the print head and make
sure it closes tightly.
Wait until the print head temperature
drops to the normal temperature
range, printer will go back to the
standby mode and the LED light will
stop flashing.
Make sure the printer is in the direct
thermal mode.
Replace with new ribbon roll.
Make sure the movable sensor mark
is at the correct position, if the sensor
is still unable to detect paper, then go
through Auto-Sensing again.
Replace with new label roll.
Possible causes: card tags or paper
felt into the gap behind the platen
roller, can't find label gap/black mark,
black mark paper out. Please adjust it
according to actual usage.
Delete unnecessary data in the
memory.
Use "~X4" command to print out all
the files, and then check whether the
file exist and the file name is correct.
Change the file name and download
again.
v.1.3
OD5+ Serie
- 28 -