Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Prism Offset
GB
0 ... 255
RPrism Offset adjustment of the rotation
-127 ... 127
Focus Offset
0 ... 255
3) Press the button ENTER to activate the function.
4) Press the button
5) To memorize, press the button ENTER. To
switch to another function, press the button
MENU,
6) To return to the previous operating mode, keep
the button MENU pressed for one second or wait
for one minute and do not press any button.
7.2 Self-test
To test the moving head, a short test program is
available. To start it:
1) Press the button MENU (4) repeatedly until the
display (5) shows Auto Test.
2) Press the button ENTER to start the test run. At
the end of the test, the light beam is deactivated
and the head returns to its starting position.
3) To return to the previous operating mode, keep
the button MENU pressed for one second or wait
for one minute and do not press any button.
7.3 Indication of temperature, operating
hours and firmware version
Press the button MENU (4) repeatedly until the dis-
play (5) shows the corresponding menu item:
Temp.
Fixture
Time
Firmware
Version
Press the button ENTER to confirm. The display
shows the desired information. To return to the pre-
vious operating mode, keep the button MENU
pressed for one second or wait for one minute and
do not press any button.
22
Downloaded from
www.Manualslib.com
fine adjustment
of prism
angle for the prism
fine adjustment
of focus setting
or
to change the setting.
or
.
to indicate the temperature (°C)
inside the moving head
to indicate the operating hours
to indicate the firmware version
(operating system of the moving
head)
manuals search engine
7.4 Activating the factory settings
The factory settings are suitable as basic settings,
e. g. when installing the TWIST-52LED at a new
location.
Factory settings
DMX Address
001
DMX start address 1
Channel Mode
15
Number of DMX channels 15
Show Mode
Show 1 Show program 1
Split Color
No
Light patterns in two colours no
Slave Mode
Slave1 Slave mode 1
Black Out
No
Blackout mode no
Sound State
On
Music control on
Sound Sense
90
Microphone sensitivity 90
Pan Inverse
No
Pan direction normal
Tilt Inverse
No
Tilt direction normal
Back Light
On
Display backlight on
Focus1 Adjust 178
Focus setting for gobo wheel 1
Focus2 Adjust 76
Focus setting for gobo wheel 2
1) Press the button MENU (4) repeatedly until the
display (5) shows Factory Settings.
2) Press the button ENTER. On the display, No
starts flashing. (To cancel, press the button
ENTER.)
3) Press the button
or
the button ENTER to activate the factory set-
tings. The display shows Factory Set-
tings again.
4) To return to the previous operating mode, keep
the button MENU pressed for one second or wait
for one minute and do not press any button.
7.5 Reset
In case of malfunction, a reset of the moving head
may eliminate the problem:
1) Press the button MENU (4) repeatedly until the
display (5) shows Reset.
2) Press the button ENTER. During the reset, the
display shows LED-MS50. Then the moving
head returns to the previous operating mode.
3) A reset is also possible during DMX mode. For
this purpose, set DMX channel 15 (in 15-chan-
nel mode) or channel 16 (in 16-channel mode) to
a DMX value between 200 and 209 (
ter 9.2).
to switch to Yes. Press
chap -
Werbung
Kapitel
Inhaltsverzeichnis
