Important Warnings - Compak K-6 Bedienungshandbuch

!
6.3. Putting the grinder into place
The grinder should be installed on a smooth flat surface. In order to
guarantee the optimum performance of the appliance, the minimum
dimensions of the work place should be as follows:
K-6 / K-6 Silenzio
K-6 Prof. Barista / K-8
K-8 Silenzio / K-10 Conic
K-10 Conic WBC
6.4. Installation of the coffee grinder
Before connecting the coffee grinder, check the following:
•That the data on the features label coincides with those of the power supply.
• That the electrical current is appropriate for the machine.
• That the connection point to the power supply network is protected with
appropriate fuses.
• That the equipment is properly connected to a grounded so-cket in
accordance with the applicable safety guidelines.
*The coffee grinder should be used in areas with a room temperature
below 25/30ºC ( 77/86ºF ) and should not be installed in places (SUCH
AS INDUSTRIAL KITCHENS) where cleaning with water jets is used.
Downloaded from www.Manualslib.com

6.2. Important warnings

The operator must be a responsible adult and under no cir-cumstances a
minor or a person unable to deal with said respon-sibility.
When handling the grinder, the following precautions must be taken into
consideration:
• Do not handle with bare feet
• Hands or feet must not be wet
• Do not submerge the machine in water
• Do not expose the machine to sunlight or other atmospheric
conditions
• Never insert any object into the coffee input or output openings
when the machine is turned on. (Please bear in mind that when the
grinder stops, the burrs continue to turn for a few seconds.)
• To disconnect the grinder, always pull out the plug and never the
electrical cable, to avoid the possibility of a short circuit.
MODEL Height (in / mm.) Width (in / mm.) Depth (in / mm.)
manuals search engine
31.5 / 800 12.1 / 310 16 / 406