Specifications - Makita DPJ140 Betriebsanleitung

ENGLISH
(Original instructions)
1 Button
2 Red indicator
3 Battery cartridge
4 Star marking
5 Indication lamp
6 Pointer
7 Stopper
8 Adjusting screw
9 Rubber spike
10 Lock lever
11 Angle guide
12 Knob
13 Scale

SPECIFICATIONS

Model
Type of blade
Max. grooving depth
–1
No load speed (min )
Overall length
Net weight
Rated voltage
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from
country to country.
• Weight, with battery cartridge, according to EPTA-Pro-
cedure 01/2003
Intended use
The tool is intended for cutting crescent shaped slots for
the placement of flat wooden dowels or biscuit by a
plunging action.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future refer-
ence.
CORDLESS PLATE JOINER SAFETY
WARNINGS
1. Blades must be rated for at least the speed
marked on the tool. Blades running over rated
speed can fly apart and cause injury.
2. Always use the guard. The guard protects the
operator from broken blade fragments and uninten-
tional contact with the blade.
3. Use only the blades specified for this tool.
6
Explanation of general view
14 Tighten
15 Loosen
16 Down
17 Up
18 Center of blade thickness
19 Fence
20 Angle scale
21 Blade cover
22 Set plate
23 Thickness of set plate
24 Slide switch
25 Lock nut
26 Plate joiner blade
DPJ140
D.C. 14.4 V
4. Never operate the tool with the blade locked in
exposed position or without the blade cover
secured properly in place.
5. Make sure that the blade slides smoothly before
operation.
6. Check the blades carefully for cracks or damage
before operation. Replace cracked or damaged
blades immediately.
ENE013-1
7. Make sure that the flange fits in the arbor hole
when installing the blade.
8. Inspect for and remove all nails or foreign matter
from the workpieces before operation.
9. Always place the workpieces on a stable work-
bench.
GEA010-1
10. Secure the workpieces firmly with clamp or vise.
11. NEVER wear gloves during operation.
12. Hold the tool firmly with both hands.
13. Keep your hands and body away from the groov-
ing area.
14. Run the tool for a while without the blade point-
ing toward anybody. Watch for vibration or wob-
bling that could indicate poor installation or a
poorly balanced blade.
GEB093-1
15. Never reach your hands underneath the work-
pieces while the blade is rotating.
16. Do not leave the tool running unattended.
17. Always be sure that the tool is switched off and
the battery cartridge is removed before making
any adjustments or replacing the blade.
18. Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation
and skin contact. Follow material supplier safety
data.
19. Do not use blunt or damaged blades.
27 Inner flange
28 Clamp screw
29 Shaft lock
30 Dust bag
31 Fastener
32 Dust nozzle
33 Exhaust vent
34 Inhalation vent
35 Limit mark
36 Holder cap cover
37 Screwdriver
38 Brush holder cap
DPJ180
Plate Joiner
20 mm
6,500
351 mm
3.0 kg
D.C. 18 V