Klarstein Coolzone 130 Handbuch Seite 31

Remove the 4 screws from the front of the door. Then attach the two guides to the door
with the 4 screws.
3
Slowly and carefully slide the unit into the
cabinet. Make sure that the opening side
is as close as possible to the cabinet wall
and that the front is flush with the front of
the built-in cabinet.
2
4
Open the unit door and the door of the
built-in cabinet by 90°. Place the sliders
at the top and bottom in the guides and
pull the sliders out 62 mm (see picture).
Then fasten both sliders on the right side
to the door of the built-in cabinet with
one screw each. Mark the position of the
sliders on the door of the built-in cabinet.
EN
31