End Point Filter Mode - Miscea Remote Control Betriebsanleitung

5. Additional Settings
5.7 miscea System Settings for Instantaneous Water Heaters
Please check the software version on the waterbox component. The available settings
are used in combination with instantaneous water heaters when the water pressure
DURATION
from the hot and cold supply lines are unequal.
DEFAULT
Press the buttons indicated in the following order: «DURATION» button, «DEFAULT»
button, «LANG» button. With the «+» and «-» buttons, the cycle through the 3 available
settings. To save settings, press the «SAVE» button. All colored LED lights illuminate to
LANG
indicate the new setting has been saved. If the «SAVE» button is not pressed within 10
seconds of the last selection, the previously saved setting will be stored.
SETTING 1: compatible with waterbox software version 0.23
SETTING 2: compatible with waterbox software version 0.24
This function is available with faucet software version starting from version number indicated next to each model.
Position
Bar position
Setting
CLASSIC (v.1.56+)
KITCHEN (v.0.41+)
5.8

End point filter mode

The end point filter mode is to be used in combination with the miscea end point filter
adapter/accessory. When this mode is enabled, water is dispensed when the water
SPOOL
sector is selected or when a hand is placed under the faucet water outlet. The water
begins to flow and continues to flow even when hands are no longer within the sensor
TEMP
detection range. To stop the water flow, the water sector must once again be selected
or a hand must once again be placed under the faucet water outlet.
LANG
Press the buttons indicated in the following order: «SPOOL» button, «TEMP» button,
«LANG» button. With the «+» and «-» buttons, the end point filter mode can be enabled
and disabled. To save settings, press the «SAVE» button. All colored LED lights illumi-
nate to indicate the new setting has been saved. If the «SAVE» button is not pressed
within 10 seconds of the last selection, the previously saved setting will be stored.
This function is available with faucet software version starting from version number indicated next to each model.
Position
Bar position
End Point Filter mode
CLASSIC (v.1.61+)
LIGHT (v.1.23+)
NOTE: For the CLASSIC Pure W Model, the bottom water sector will be deactivated when this function is enabled.
1 2 3
DEFAULT
Ä
Ä
1 2 3
OFF
Ä
Ä
4 5 6
1
4 5 6
25
7 8 9
2
7 8 9
ON
V 20.01