Change Initial Water Temperature; Change Water Shut Off Delay Time - Miscea Remote Control Betriebsanleitung

3. Use
3.5

Change initial water temperature

Compatible systems allow water temperature to be set at the preferred level in the
initial water temperature setting.
TEMP
Press «TEMP» button. The «+» and «-» sectors on the faucet will light up red and blue
respectively. With the «+» and «-» buttons on the remote control, the initial starting
water temperature can be changed. To save settings, press the «SAVE» button. All
colored LED lights illuminate to indicate the new setting has been saved. If the «SAVE»
button is not pressed within 10 seconds of the last selection, the previously saved
setting will be stored.
Position
Bar position
Initial water temperature
CLASSIC
KITCHEN
3.6

Change water shut off delay time

Water shut off delay time refers to the duration of water flow from the point of time
hands are outside the detection range of the water sector. For example, water
DELAY
continues to flow for (X) seconds after hands are removed from water sector.
Press the «DELAY» button. The water sector will light up. With the «+» and «-» buttons,
the water shut off delay time can be changed. To save settings, press the «SAVE»
button. All colored LED lights illuminate to indicate the new setting has been saved. If
the «SAVE» button is not pressed within 10 seconds of the last selection, the previously
saved setting will be stored.
Position
Bar position
Water shut off delay
in seconds
CLASSIC
LIGHT
KITCHEN
1 2 3
Min
Ä
Ä
1 2 3
Min
0.5 1 1.5
Ä
Ä
Ä
14
4 5 6
4 5 6
2 3 5
7 8 9
Max
7 8 9
Max
10 30 60