Enable / Disable The Public Mode; Change The First Water Cycle Delay Time - Miscea Remote Control Betriebsanleitung

4. Public Mode
4.1

Enable / Disable the Public Mode

miscea LIGHT Model
Press the buttons indicated in the following order:
«LIQUID 2» button,
Enable: «+» button / Disable: «-» button,
«SAVE» button.
LIQUID 2
4.2 Change the short water cycle delay time
The short water cycle delay time refers to the waiting state the faucet is in after the soap has been
dispensed, to give the user an opportunity to lather soap on their hands without the water flushing the
soap away immediately. Refer to letter A in Fig. G.
miscea LIGHT Model
With the Public Mode enabled, press «MEMO»
button on the remote control.
MEMO
The water sector will light up. With the «+» and «-» buttons, the delay time can be changed. To save
settings, press «SAVE» button. All colored LED lights illuminate to indicate the new setting has been
saved. If the «SAVE» button is not pressed within 10 seconds of the last selection, the previously saved
setting will be stored.
These functions are available with faucet software version starting from version number indicated next to each model.
Position
Bar position
Enable / Disable
CLASSIC Pure S (v.1.63+)
LIGHT (v.1.22+)
First water cycle delay time
in seconds
CLASSIC Pure S (v.1.63+)
LIGHT (v.1.22+)
SAVE
1 2 3
Min
OFF
Ä
Ä
0 0.5 1
Ä
Ä
19
miscea CLASSIC Pure S Model
Press the buttons indicated in the following order:
«LIGHT», «LIQUID 2», «LANG» buttons,
Enable: «+» button / Disable: «-» button,
«SAVE» button.
LIGHT
LIQUID 2
miscea CLASSIC Pure S Model
With the Public Mode enabled, press the buttons
indicated in the following order:
BUCKET
LIGHT
4 5 6
1.5 2 2.5
LANG
SAVE
LANG
7 8 9
Max
ON
3 3.5 4
V 20.01