Cleaning Mode; Miscea System Settings For Instantaneous Water Heaters - Miscea Remote Control Betriebsanleitung

5. Additional Settings
5.6

Cleaning Mode

The Cleaning-Mode enables the user to temporarily deactivate the sensors on the
faucet for 2 minutes.
SPOOL
Once activated with the miscea remote control, the user simply needs to
LIGHT
simultaneously activate the soap and disinfectant sectors for 3 seconds or until a beep
tone is heard. The bars on the display will animate to indicate the sensors on the faucet
are temporarily deactivated to enable easy cleaning of the faucet without accidentally
LANG
activating any of the sensors.
After 2 minutes, the system will automatically exit the cleaning mode. To manually exit
the Cleaning-Mode, place hand over the soap and disinfectant sectors at the same time
for 3 seconds.
Press the buttons indicated in the following order: «SPOOL» button, «LIGHT» button,
«LANG» button. With the «+» and «-» buttons, the cleaning mode can be enabled and
disabled. To save settings, press the «SAVE» button. All colored LED lights illuminate
to indicate the new setting has been saved. If the «SAVE» button is not pressed within
10 seconds of the last selection, the previously saved setting will be stored.
miscea CLASSIC
Hold for
3 seconds
This function is available with faucet software version starting from version number indicated next to each model.
Position
Bar position
Cleaning mode
CLASSIC (v.1.56+)
KITCHEN (v.1.58+)
Sensors disabled
for 2 minutes
1 2 3
OFF
Ä
Ä
24
miscea KITCHEN
Hold for
3 seconds
4 5 6
Sensors disabled
for 2 minutes
7 8 9
ON