Electrolux IK307BNL Benutzerinformation Seite 20

20 www.electrolux.com
Problem
Water flows on the rear
plate of the refrigerator.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Water flows on the floor.
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The gasket is deformed or
dirty.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
Appliance is fully loaded
and is set to the lowest
temperature.
Temperature set in the ap‐
pliance is too low and the
ambient temperature is too
high.
During the automatic de‐
frosting process, frost
melts on the rear plate.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
The "FastFreeze function"
or "FastCool function" is
switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
Solution
Refer to "Closing the door"
section.
Wrap the food products
better.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
This is correct.
Open the door only when
necessary.
Make sure the door is
closed completely.
Wrap food in suitable
packaging before storing it
in the appliance.
Attach the melting water
outlet to the evaporative
tray.
Switch off "FastFreeze
function" or "FastCool
function" manually, or wait
until the function deacti‐
vates automatically to set
the temperature. Refer to
"FastFreeze function" or
"FastCool function" sec‐
tion.
Set a higher/lower temper‐
ature.
Refer to "Closing the door"
section.