urmet 1067 Bedienungsanleitung Seite 4

Location
C Expansion 1067/008A or 1067/011
D Expansion 1067/008A or 1067/010 or 1067/020 or 1067/011
The module can be installed in three different ways:

Inside the 1067/xxx control unit in a special location (see Fig. 8 and location table).

Wall fitted by means of screws and bolts (see Fig. 4). Use box Ref. 1067/018.

In a flush-mounting box.
Place the device in a place:

At a height not exceeding 2 metres from the floor.

Not subject to excessive fluctuations in temperature.

Protected by the burglar alarm system.

Away from strong electromagnetic fields.
If you have chosen to connect the device to the home network via WiFi, check that there is sufficient range.
If you have chosen to connect the device to the home network through a cable (Ethernet):

In the case of using the box Ref. 1067/018 with the aid of a special tool, (see Fig. 3) make an
opening on the cover for the passage of the Ethernet cable (connector).

Prepare everything you need to connect the Ethernet cable to an appropriate connector of the
device (see Legend Fig. 1).
If it is not located in the box Ref. 1067/018, the tamper must be excluded by positioning the DIP4 in the ON
position (see Legend Fig. 1).
4
Fig. 8
Device
Box bottom of
the 1067/024 –
1067/032A
control unit
DS1067-107A