Operation; Manual Restart; Switching The Pump Off; Operating Status Displays - AL-KO Hydrocontrol Betriebsanleitung

GB

6 OPERATION

Commission the appliance as described.
The pressure switch is electronically controlled
and operates fully automatically after commis-
sioning.
6.1

Manual restart

1. After malfunctions or if no water is pumped
during commissioning, the pump has to be
started manually.
2. Check the suction side of the appliance and
the water level.
3. Start the pump by pressing the "RESET" (8)
button.
4. If no water is pumped after several unsuc-
cessful attempts, check the screw fittings for
tightness and fill the pump again.
6.2

Switching the pump off

1. Remove the mains plug from the plug socket.
6.3

Operating status displays

The operating statuses are signalled by means of
indicator lights (LED).
"Power" indicator light (5)
Indicates whether the appliance is connected to
the mains power supply.
"Failure" indicator light (6)
Indicates that a malfunction has occurred.
"On" indicator light (7)
Indicates that the pump is in operation.
18

7 MAINTENANCE AND CARE

DANGER!
Danger of electric shock.
When working on the
pump, there is the risk of
receiving an electric shock.
■
Disconnect the mains
plug before correcting
any malfunctions!
■
Faults in the electrical
system must be rectified
by a qualified electri-
cian.

8 STORAGE

NOTE
If there is the danger of frost, the system
must be completely drained and the
pump must be stored in a frost-proof
place.

9 DISPOSAL

Electrical and electronic appliances do not
belong in household waste, but should be
collected and disposed of separately.
The packaging, device and accessories are
made of recyclable materials, and must be dis-
posed of accordingly.
Operation
Hydrocontrol