Installation And Commissioning - Miele XKM RS232 10 Med Montageanweisung

en - Fitting and installation
30

Installation and commissioning

 Before installing the communication module compare the con‐
nection data (voltage and frequency) on the data plate with that on
the data plate of your washer-disinfector. If the data does not
match, the module could sustain damage. If in any doubt, consult
an electrician.
The washer-disinfector must be disconnected from the mains elect‐

ricity supply before any maintenance or repair work is carried out.
Loosen the screws at the bottom of the back panel, disengage and

remove the back panel upwards.
Remove any stickers or protective caps as necessary from the slot

aperture.
Push the module into the module slot. Gently push the module until

it clicks into place.
Refit the back panel

Connect the cable between the module and the terminal device.

Ensure when connecting the cable that it does not become kinked
or trapped.
Only use terminal devices (printers etc.) which are approved ac‐
cording to EN/IEC 60950.
Connect the washer-disinfector to the electrical supply.

The module is supplied with electricity via the washer-disinfector.
An additional electrical connection is not necessary.
Switch the washer-disinfector on using the  button.

After a couple of seconds the red LED on the module indicates that it
is ready for use and configuration of the interface can begin. To do
this, follow the information in "Further settings / Interface" in the Op‐
erating instructions for your washer-disinfector.