Safety; Residual Risks - Relyon plasma piezobrush PZ3 Betriebsanleitung

1

Safety

This device is built according to corresponding international standards. Like with every
technical product incorrect or not intended use can however be dangerous.
Follow the instructions in this operating manual in addition to the general safety regulations.
Caution - Danger!
When working with the device, please note and observe the safety instructions and
requirements in these operating instructions because non-compliance may result in
serious or fatal injury.
1.1

Residual risks

This device has been manufactured in accordance with the current state of the art.
However, it is impossible to eliminate residual risks.
Always adhere to the following safety instructions:
Caution – Electrical voltage!
Only use the external power plug provided.
Danger from mains voltage. If the external power plug is visibly damaged:
- Do not use the damaged part.
- Have the damaged parts repaired by a qualified person or replace them.
Danger from sparks on the piezo element and the substrate to be treated:
- Do not reach into the area of the plasma discharge.
- Electrically conductive substrates must be grounded or protected against touching.
Attention – Emissions!
Dangerous amounts of the reaction gas ozone (O
operation.
- Volumes of ozone in excess of 0.2 mg/m³ may be produced.
- Note that national health and safety measures must be observed when operating
the device.
- Only use the device in well ventilated areas or in conjunction with a suitable
extraction device.
- Do not leave the device running unattended.
- Do not point the device at people when in operation.
6
) may be produced during device
3
BA-PZ3_ML / F0354401