Storage And Transportation; Installation And Electrical Connection - Schüco MPE 320 MP 02 Modulmontage

General information, hazard warnings and safety advice
Do not insert electrical components into
plugs and sockets.
Ensure that all tools and working conditions
are dry.
Do not use damaged modules. Do not
dismantle modules.
Do not apply colour, adhesives or sharp
objects to the reverse side.
Ensure that the correct period of time
between switching the inverter off and
restarting it is observed as stipulated by the
manufacturer.

Storage and transportation

Installation and electrical connection

12.2008
Do not dismantle or drop
the module.
Do not bend the module.
Use both hands!
Do not hoist on the
connection boxes.
Ensure all contacts are kept
clean and dry.
Do not expose the
module to sunlight during
installation; cover the front
of the module with an
opaque towel or similar.
The PV module may not be installed near
naked fl ames or in the immediate vicinity of
fl ammable materials.
Installation of the module in corrosive
saline, ammoniacal or sulphurous areas is
not permitted.
Never separate the solar generator from
the inverter whilst it is connected to the
power network.
256 222
Do not step on the module.
Do not use pointed or sharp
objects with the module.
Maximum module load:
< 2.4 kN/m²
Artifi cially concentrated
sunlight shall not be
directed on the module!
Ensure the module is
aligned in the best position
(30° inclination / South).
11