Rittal CMC III Installations- Und Kurz-Bedienungsanleitung Seite 9

Status change display on the multi-LED of the leak sensor:
– Continuous blue flashing: Communication via the CAN bus.
– Green flashing: When the measured value changes or, at the latest, every 5 seconds.
– Continuous red flashing: The leak sensor has "alarm" status.
– Continuous red light: Invalid measured value.
If installation was unsuccessful: see section 1.1.
Note:
Connection cables in various lengths can be purchased from Rittal.
5.3 Settings
The following parameters can be set or viewed at the CMC III PU website:
– DescName: Specific description of the leak sensor.
– Position: Alarm message for leaks.
– Delay: Time delay after which the status message changes.
– Status: Current status of the leak sensor, taking account of the delay value.
For any software updates required, please visit www.rittal.com or contact Rittal Service (see section 6).
6 Service
For technical queries, please contact:
Tel.: +49(0)2772 505-9052
E-mail: info@rittal.de
Homepage: www.rittal.com
For complaints or service requests, please contact:
Tel.: +49(0)2772 505-1855
E-mail: service@rittal.de
Rittal CMC III leak sensor
Installation and operation, Service
EN
9