hanseatic XL 25 T Gebrauchsanweisung Seite 30

Petrol trimmer
Ratings
Model
Engine output
Engine type
Cubic capacity
Fuel lubricated petrol
Tank volume
Maximum engine speed
Idling speed
Max. speed of the cutting tool
Fuel consumption
Cutting diameter
Cord diameter
Overall cord length
Cord extension
Weight
Acoustic capacity level
Sound pressure level (acc. to EN 27917)
Vibration – full throttle (acc. to EN ISO 7916)
Vibration – idling (acc. to EN ISO 7916)
Cutting attachments (type)
Technical changes reserved.
The devices are manufactured in accordance with the provisions of DIN EN ISO 11806 and fully comply with the
provisions of the German Equipment and Product Safety Act.
SAFETY INSTRUCTIONS
Information on noise emission in accordance with
"Machine Noise Information Ordinance 3. GPSGV
and Machinery Directives: The noise level at the
workplace may exceed 85 dB (A). In this case, noise
protection measures for the operator are required
(e.g., wearing of ear protection).
Attention: Noise protection ! Please observe the
local regulations when operating your device.
BEFORE OPERATION
• Always keep these Operating Instructions to hand
together with your petrol trimmer.
• Read the instructions carefully. Familiarise with
the control elements so that you are able to safely
operate the device.
• Children and juveniles are not allowed to operate
the device – except for juveniles working with the
device under the guidance and supervision of an
adult who is familiar with the device.
• Before each use of the device, check whether the
cutting head is attached correctly and that the throttle
lever returns to zero position automatically.
• All protection covers and safety devices must be
correctly attached to operate the device.
• Thoroughly check the device for loose or defective
parts before each use. Only start working with the
device when all required repairs and settings
have been effected.
• Use the device only during daylight or in sufficiently
Downloaded from www.Manualslib.com manuals search engine
XL 25 T
kW / HP 0.8 / 1.1
2-stroke
cm 25
3
40:1
ml 600
min -1 10.500
3.000
min
-1
min 9.000
-1
kg/h 0.38
cm 43
mm 2.0
m 2 x 3
Tap'n go
kg 4,5
dB(A) 112
dB (A) 98,2
6,35
m/s
2
m/s 9,57
2
Nylon line cutting head
strong artificial light.
• Take care that no other persons are standing within
a radius of 15m around your working area.
• Adjust the handle to your body height before starting
the device and make sure that the cutting head is
not in touch with any objects.
• Be aware of the possible dangers to your head,
hands and feed that may develop.
• Carefully check the area to be cut down. Remove
any fallen leaves that may get caught in the cutting
cord. Also remove any objects that may be hurled
away during cutting.
SAFETY INSTRUCTIONS FOR PETROL-POWERED
TRIMMERS AND BRUSHCUTTERS
WARNING: Petrol is extremely flammable and its
fumes may explode when ignited. Take care of the
following:
1) Store petrol in containers designed and approved
for the storage of such substances only.
2) Always switch off the engine and let it cool down
before you refill the tank. As long as the engine is
hot you must never remove the tank cap or refill
the tank.
3) In the tank pressure may develop. Loosen the
tank cap slowly to allow this pressure to gradually
decrease.
4) Refuel the device in a clean, well-ventilated room
only. Immediately wipe off spilled-over fuel. In such
a case, you must keep all sources of ignition away
from the device and wait with the starting of the
engine until the fuel has evaporated.
GB-2