Mcacc Data Check - Pioneer VSX-S520D Bedienungsanleitung

> Before Start > Part Names
Surround Left After selecting the speaker frequency from between "63 Hz" and
"16 kHz" with the cursors /, adjust the volume of that
frequency between "-12.0 dB" and "+12.0 dB" with /. (Default
Value is "0.0 dB")
0 If an item cannot be selected even though connection is
correct, check that the settings in "System Setup" - "Speaker"
- "Configuration" - "Speaker Channels" (P49) matches the
number of connected channels.
0 "63 Hz" can only be selected when this speaker is set to
"Large" in "System Setup" - "Speaker" - "Crossover" (P49).
Subwoofer After selecting the speaker frequency from between "31 Hz" and
"250 Hz" with the cursors /, adjust the volume of that
frequency between "-12.0 dB" and "+12.0 dB" with /. (Default
Value is "0.0 dB")
0 This cannot be selected if "No" is set in "System Setup" -
"Speaker" - "Configuration" - "Subwoofer" (P49).
0 The result may not be as expected depending on the input source and listening mode
setting.
0 If you want to make the adjustments while listening to something, press
controller, and select the Preset you want to adjust in "AV Adjust" - "MCACC" - "Manual
EQ Select" (P44) first.
58
> Install > Initial Setup
on the remote
> Playback
Supplementary information |

MCACC Data Check

You can check the number of speaker channels connected and the content and values you
have set for each of the speaker settings.
∫ Speaker Setting
You can check the number of speaker channels connected and the large and small settings
you have set for the low range reproduction capabilities for each of the speakers.
∫ Channel Level
You can check the output level settings for each of the speakers.
∫ Speaker Distance
You can check the distance from each speaker to the listening position.
∫ Acoustic Calibration EQ
You can check the calibration values for the frequency characteristics of each speaker that
were set in "Manual MCACC".
Advanced Setup | Others
E
N