Audio Adjust - Pioneer VSX-S520D Bedienungsanleitung

> Before Start > Part Names
Surround Right Select a value between "-12 dB" and "+12 dB" (in 1 dB
increments). A test tone will be output each time you change the
value. Select the desired level (Default Value is "0 dB").
Surround Left Select a value between "-12 dB" and "+12 dB" (in 1 dB
increments). A test tone will be output each time you change the
value. Select the desired level (Default Value is "0 dB").
Subwoofer Select a value between "-15 dB" and "+12 dB" (in 1 dB
increments). A test tone will be output each time you change the
value. Select the desired level (Default Value is "0 dB").
∫ Dolby Enabled Speaker
Dolby Enabled Set the distance between the Dolby enabled speaker and the
Speaker to Ceiling ceiling. Select a value between "0.1 ft/0.03 m" and "15.0 ft/
4.50 m" (in 0.1 ft/0.03 m increments, default value is "6.0ft/
1.80 m")
0 The unit of distance (feet/meters) shown is the unit selected
for use in "Distance".
0 Default values vary depending on the regions.
Reflex Optimizer You can enhance the reflection effect of Dolby enabled speaker
from the ceiling.
"On": When this function is to be used
"Off (default value)": When this function is not to be used
0 The function is not effective if the listening mode is Pure
Direct.
0 This setting can only be selected when you have set "Configuration" - "Height Speaker" to
"Dolby Speaker".
> Install > Initial Setup > Playback
Supplementary information |

Audio Adjust

∫ Dual Mono/Mono
Dual Mono Set the audio channel or language to be output when playing
multiplex audio or multilingual TV broadcasts etc.
"Main (Default Value)": Main channel only
"Sub": Sub channel only
"Main / Sub": Main and sub channels will be output at the same
time.
0 If multiplex audio is being played, "1+1" will be displayed on
the display of this unit when
pressed.
Mono Input Channel Set the input channel to use for playing any 2 ch digital source
such as Dolby Digital, or 2 ch analog/PCM source in the Mono
listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right (Default Value)": Left and right channels
∫ Dolby
Loudness When playing Dolby TrueHD, enable the dialog normalization
Management function which keeps the volume of dialog at a certain level. Note
that when this setting is Off, the DRC function that allows you to
enjoy surround at low volumes is fixed to off when playing Dolby
Digital Plus/Dolby TrueHD.
"On (Default Value)": Use this function
"Off": Do not use this function
∫ Volume
Volume Limit Set the maximum value to avoid too high volume. Select "Off
(Default Value)" or a value between "30" and "49".
Headphone Level Adjust the output level of the headphones. Select a value
between "-12 dB" and "+12 dB". (Default Value is "0 dB")
Advanced Setup | Others
E
N
on the remote controller is
51