Herunterladen Inhalt Inhalt Diese Seite drucken

Additional Safety Instructions - CO/Tech JFB10-UK Original Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

20. Use the correct extension leads. If you use extension leads outdoors, only use those designed for outdoor
use. Only use extension leads with thick enough diameter core wires and roll out the whole lead.
21. Use common sense and be careful. Think before carrying out any task, so that it is carried out safely.
Never operate machines/power tools when you are tired or under the influence of medicine.
22. Check the following before turning the tool on:
That all guards and other parts are whole and in working order.
That moving parts are free and correctly aligned.
That no moving parts can get caught.
That there are no visible defects.
Other factors that can influence work execution.
23. Use only recommended accessories. The use of accessories which are not recommended by
the manufacturer may present a risk of personal injury.
24. Check that the tool conforms to current safety regulations. Repairs to the tool should only be carried out by
a tradesman using original spares; otherwise the tool could cause accidents and personal injury.

Additional safety instructions

If using a floor stand, make sure that the band saw is securely fastened to the stand and that the stand is
properly assembled and securely fastened to the floor.
Make sure that the band saw is positioned in such a way that the workpiece can be worked on in a safe manner.
This saw must not be used for wet cutting. Doing so can lead to deadly electric shocks. This band saw is
only intended for dry cutting.
The drive belt must not be put under too much tension; it will last longer if the tension is released when
the saw is not in use.
Do not allow the build-up of sawdust around the motor or inside the machine. Piles of sawdust are a fire hazard.
The sawblade must not be stopped through the exertion of pressure on the workpiece or by apply force to
the sides of the blade.
The machine's safety guards must be in place and functioning properly. Always check that the blade guides
are correctly aligned.
Never turn the machine on if the saw blade is in contact with the workpiece.
Make sure that there are no nails or screws in the workpiece which could damage the saw blade.
Do not attempt to modify the machine or its accessories in any way.
Do not apply too much pressure to the workpiece when feeding it into the saw blade. A steady feed
rate reduces wear on the saw and saw blade and consequently increases the efficiency and useful life of
the band saw. Replace any worn table inserts.
Connect the band saw to a dust extractor before starting to saw. The saw must not be used if any of its
panels is open or if the blade guard is not in place.
Select an appropriate saw blade and sawing speed for the type of workpiece.
When sawing with a tilted table, position the guide on the lower side of the table.
Position the blade guard as close to the workpiece as possible.
Saw blade safety
Use only blades recommended by the manufacturer/supplier.
Do not use a damaged or deformed saw blade. Doing so could result in considerable danger to the user
or damage to the machine.
The direction marked on the saw blade should correspond to the direction of the pulley's rotation.
The teeth of the blade should be pointing downwards when the blade is viewed from the side.
3

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Diese Anleitung auch für:

Jfb1018-320540-7894

Inhaltsverzeichnis