GLATZ Sun Comfort PSV16 Einbauanleitung

GB
SUNCOMFORT
IN-GROUND PSV16
Fitting Instruction
Alignement:
• The Flange of the in-ground must be fitted exactely horizontal.
• The edge of the sunshade must be parallel to either the edge of the flange or to the flange diagonal of the floor
fitting, as shown in image ( A ).
• Distance between canopy-edge to canopy-edge or fix obstacles must be at least _ > 20cm
Concrete cast:
• The fitting has to be carried out by an adequate specialiste ( eg: brick-layer )
• The eight tap-holes ( 1 ) of the In-ground ( 3 ) need to be sealed with tape, to prevent
that liquid concrete ( 4 ) flow into the holes.
• Dimension of foundation has to be according the spreadsheet!
• Rainwater must be able to drain off. Fill in below the tube some gravel ( 5 ).
• Place two mesh-reinforcement ( 2 ) into the concrete.
• Loose covering ( without concrete ) is allowed to maximum measure of ( c )
• Installation above 1000m sea-level require b _ > 50 cm because of frost depth.
Remark:
• Installation has to be conform the manual. Disregard or change of installation can result
on serious damages to people and material for which the manufacturer refuses to accept any
liability or obligation under warranty.
technische Änderungen vorbehalten / sous réserve de modification techniques / con riserva di modifiche tecniche / we
reserve the right to make technical alterations
Suncomfort by Glatz - www.suncomfort.ch
BODENHÜLSE PSV16
Einbauanleitung
Bodenhülse PSV16
Instruction de montage
Douille a enfoncer PSV16
Istruzioni di installazione
Boccola da pavimento PSV16
Fitting instruction
In-Ground PSV16
12.2016 -DEF