Conventional Application; Qualified Staff; Accuracy Of The Technical Documentation - Weidmuller 6/70 Serie Betriebs- Und Wartungsanleitung

Introduction
1.2

Conventional application

The Crimping tools of the series 10/120 are only for crimping copper or aluminium ca-
ble lugs and connectors of cross sections which are listen in the technical data. For
each kind of cable lug and connector you have to choose the right type of the tool.
A different usage than mentioned above is not intended and therefore not permitted.
The instructions given in this manual must be absolutely followed.
Do not use the crimping tools for other cable lugs or connectors than mentioned below:
Crimping tool PZ RK 10/120, Art. Nr. 1500450000
Only for processing Weidmüller cable lugs and connectors of the euro-series.
Compatible to many series of other manufacturers.
Crimping tool PZ PK 6/70, Art. Nr. 1500440000
Only for processing compression copper cable lugs DIN 46235, compression copper
connectors DIN 46267 part 1 and compression aluminium cable lugs and connectors
DIN 46267 part 2.
1.3

Qualified staff

These operating instructions have been written for trained and qualified personnel who
are familiar with the valid regulations and standards applicable to the field of application.
1.4

Accuracy of the technical documentation

These operating instructions were created with all due care and attention. However, as
long as not prescribed otherwise by law, we cannot guarantee that data, pictures and
drawings are accurate or complete, nor do we assume any liability for the contents. The
applicable terms and conditions for Weidmüller apply in their current form. This docu-
ment is subject to alteration without notice.
24 1548650000/00/06.14