Storage; Disposal - Zipper Maschinen ZI-MD500HSN Betriebsanleitung

14.11

Storage

If the machine is stored for longer than 30 days:
 Drain the fuel tank completely and store the drained fuel in a suitable container.
 Start the machine and let it run until it stops. This helps to prevent gum deposits from
forming inside the carburettor and possible motor damage.
 Wait until the machine has cooled down sufficiently.
 Clean the machine with a clean cloth and keep the ventilation slots free of deposits.
 Tighten loose screws, nuts or bolts.
 Replace damaged machine components immediately.
 Store the machine in a dry, clean place, well packaged.
NOTICE: do not store the machine with fuel in a non-ventilated area. Fuel fumes can be ignited
by flying sparks.
14.12

Disposal

Do not dispose the machine, machine components fuel and oil in residual waste.
Contact your local authorities for information regarding the available disposal options.
When you buy at your local dealer for a replacement unit, the latter is obliged to
exchange your old.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-MD500HSN
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
1. Lift the machine and set it on blocks
2. Adjust the bolt M20x180 to move the guiding
wheel assembly toward the driving wheels.
Then the tracks will get loose enough.
C A U T I O N
When removing and replacing the chain,
make sure that you pinching your hands
between the wheel and the chain.
3. Slip old tracks off and install the new tracks.
4. Adjust bolt M20x180 to assure correct tightness
of the tracks.
5. Secure bolt M20x180 by tightening locknut
thoroughly.
45