Stop The Machine; Dump Box Lifting And Lowering; Cleaning, Maintenance, Storage, Disposal; Cleaning - Zipper Maschinen ZI-MD500HSN Betriebsanleitung

13.3.4

Stop the machine

To stop the machine in an emergency, release the clutch lever and turn the ON-OFF-Switch to
the "OFF" position.
Under normal conditions, proceed as follows.
1. Move the throttle lever to the "SLOW" position.
2. Allow engine to idle for 1-2 minutes.
3. Turn the ON-OFF-Switch to the "OFF" position.
4. Turn the fuel valve lever to the "CLOSED" position.
NOTICE:
 Sudden stops of the machine at high speed and under heavy load are not recommended.
Motor damages may result.
 Not move the choke lever to stop the engine to "CLOSED". Risk of reignition or damage
to the motor!
13.3.5

Dump box lifting and lowering

14

CLEANING, MAINTENANCE, STORAGE, DISPOSAL

No cleaning, upkeep, checks or maintenance when machine is running
14.1

Cleaning

Procedure:
1. Turn off the machine and declutch all command levers.
2. Allow the machine to cool down.
3. Move the throttle lever to the "SLOW" position and remove the spark plug connector
from the spark plug.
4. Use a soft brush or vacuum cleaner to remove dust and other debris from the machine
after each use.
5. Impregnate bare surfaces of the machine against corrosion (e.g. with rust protection
agent WD40)!
6. After cleaning, reattach the spark plug connector.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-MD500HSN
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
1. Pull the locking plate (A) up to release the tipping
handle.
2. To raise the tipping box, pull the tipping handle
upwards (B). The hydraulic system lifts the dumper
box.
To stop raising the dumper box, simply release the
tipping handle and return the locking plate (A) to its
original position.
3. To lower the dumper box, first pull the locking plate
up (A) to release the tipping handle, and then pull
the tipping handle down (C).
When the dumper box is lowered to the original
position, release the tipping handle back to its
original position and lock securely with the locking
plate (A).
W A R N I N G
Shut off the machine and let it cool down before start servicing!
39