Checklist Before Starting Up; Checking The Engine Oil Level - Zipper Maschinen ZI-MD500HSN Betriebsanleitung

12.4

Checklist before starting up

The use of paint thinners, gasoline, aggressive chemicals or scouring agents leads
to material damage to the surfaces! For cleaning, therefore, only use mild cleaning
agents!
 Clean the machine and if necessary remove dirt and dust.
 If the air filter is dirty, blow through the filter cartridge from the inside by moving a
jet of dry compressed air up and down. Continue to do this until all dust is removed. If
necessary, replace the air filter by a new one.
 Check the carburettor for external dirt and dust and clean it with dry compressed air if
necessary.
 Check lock nuts, screws and bolts for tightness. (Screws or bolts that have been
loosened by vibration can lead to accidents!)
 Check motor-oil level.
12.4.1

Checking the engine oil level

ATTENTION! For transport motor oil has been drained. Fill up with 4-
stroke quality motor oil before first operation! Failure to do so will result
in permanent motor damage and void guarantee!
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-MD500HSN
Mounting landing legs onto the snow blade
 Mount the two landing legs (10) onto the snow
blade. Place the landing leg weldment into the
bracket and fix it with the hex bolt M12X40 (11)
and nut (12).
Assembly snow blade
 Install the already assembled snow blade onto
the machine with the two delivered pins 20X80
(13) and fix it with the bigger pin (15).
 The snow blade can be tilted in three positions:
- Straight position place bolt (1) in position
(Pos2).
- Tilt it to the left, place bolt (1) in position
(Pos1).
- Tilt it to the right, place bolt (1) in position
(Pos3).
N O T I C E
W A R N I N G
ASSEMBLY
34